Nothing wears on homeowners like the idea of handling plumbing problems. From the water heater to sewer line, let Mr. Rooter Plumbing take the pressure off of you (and put it back in your shower lines). Our plumbers are the most recognized professionals in the world because we’re committed to amazing service and amazing results. In everything we do, our team makes sure your home’s plumbing issues are solved with the most effective and long-lasting solutions.
Here is an odd problem that I cannot figure out. I am handy with electrical stuff, but this one has me stumped. My small kitchen appliances all work on a single circuit, with 5 outlets. One of those outlets has a 20Amp breaker built into it with a test and resent button (I never understood what the test button is for). I only have a toaster, a floor lamp and occasionally a coffee grinder plugged into the circuit. Suddenly, none of the outlets work. Nothing new, no new appliances, the whole circuit went dead. I noticed when I trigger the reset button, there is an immediate click and it goes out again. I have tripped and reset the main breaker on the circuit board in the garage, nothing. Power gets to the outlet, but it doesn't work and there is no electricity in any of the 5. I un plugged everything. Reset the breaker on the outlet. It clicked again immediately, still no electricity. I changed out the outlet, with a new one with breaker built in which I bought today at Home Depot. Same problem. I tested for electricity, the outlet with the built in breaker receives 120v electricity coming in, but it always seems to be shorted out and does not send it out. I assume that all of the 5 outlets are connected inline, so thinking that if I went one by one, I'd be able to find a short. I opened all of the boxes, checked everything and all looks clean, new, no problems. I completely disconnected the two outlets that are closest to the main one with thereset button and nothing.Help
I had 207 Plumbing come to fix a leak in my ceiling. It's a terrible, terrible company to do business with. He came and fixed a broken pipe in the ceiling, and I asked him to check the rest of the pipe to make sure that nothing else was broken, he said everything was OK and charged me $219.00 for 45 minutes and left. Never cleaned up his mess. I went to clean up the mess after he left and found there was more damage to the pipe. I called him to come back, which he did. He looked at the water coming down from the ceiling, into a light fixture and said he had another job to go to and couldn't come back until next week. He also wanted to charge me $350.00 to come back. I told him that was too much and he said he would make an exception and only charge me $219.00. Now I have major damage done to the ceiling, the light fixture and the floor. All of this could have been prevented if he had stayed and fixed the problem. I will NOT hire him again.
The Federal Government does not regulate licensing for plumbers; they are on a state-by-state government level. Most states have some sort of licensing requirement for plumbers and any general contractors. However, if plumbers aren’t licensed, they could be subjected to expensive fines and it could result in the loss of their being allowed to practice their trade.
Plumbing reached its early apex in ancient Rome, which saw the introduction of expansive systems of aqueducts, tile wastewater removal, and widespread use of lead pipes. With the Fall of Rome both water supply and sanitation stagnated—or regressed—for well over 1,000 years. Improvement was very slow, with little effective progress made until the growth of modern densely populated cities in the 1800s. During this period, public health authorities began pressing for better waste disposal systems to be installed, to prevent or control epidemics of disease. Earlier, the waste disposal system had merely consisted of collecting waste and dumping it on the ground or into a river. Eventually the development of separate, underground water and sewage systems eliminated open sewage ditches and cesspools.
For nonemergency projects -- a remodel or remedial work on your plumbing -- you need a pro who understands residential-system design and knows the code in your area. He also has to be able to work in a finished environment. That means putting down a piece of scrap carpeting to protect floors and cutting precise, easy-to-repair holes in walls, and, then, only when necessary.
Wooden pipes were used in London and elsewhere during the 16th and 17th centuries. The pipes were hollowed-out logs, which were tapered at the end with a small hole in which the water would pass through. The multiple pipes were then sealed together with hot animal fat. They were often used in Philadelphia, Boston, and Montreal in the 1800s, and built-up wooden tubes were widely used in the USA during the 20th century. These pipes, used in place of corrugated iron or reinforced concrete pipes, were made of sections cut from short lengths of wood. Locking of adjacent rings with hardwood dowel pins produced a flexible structure. About 100,000 feet of these wooden pipes were installed during WW2 in drainage culverts, storm sewers and conduits, under highways and at army camps, naval stations, airfields and ordnance plants.
Menards® has all the plumbing supplies you need to ensure your plumbing systems will last for years. Our water systems will keep your entire home running smoothly. We offer a variety of landscape drainage and watering and irrigation products for any home. Menards® offers water heaters for both residential and commercial buildings as well as storage tanks. Keep your water fresh and clean with our water filtration and softeners. Our whole house filtration systems will keep all of the water in your home clean and pure. We also offer water softeners to prevent hard water issues. Enjoy fresh, cool water with one of our water coolers. If you use well water, we have many pumps and well tanks as well as the accessories needed to keep it running smoothly. Our BIG selection includes sump and utility pumps, well pumps and well tanks, sewage pumps, and sprinkler pumps. We have a wide selection of rough plumbing items and pipe, tubing, hoses, fittings, and accessories to complete a variety of plumbing projects. You can also repair your plumbing systems or install new pieces with our plumbing installation and repair products. Our hydronic radiant heat systems are a great addition to commercial or pole barn buildings.
Nationally, the average water heater repair cost ranges between $120 and $200, although prices can range up to $400 or more. Water heater repair costs will depend on the type of water heater you have (tankless, electric, natural gas, etc.), the source of the problem, the cost for new parts, and labor rates in your area. Common water heater issues include problems with the thermocouple, thermostat, heating element and leaks. Most standard electric water heaters have two thermostats and two elements. One example for the cost to replace a bad thermostat is $185 for parts and labor. Replacing both the thermostat and the heating element could cost approximately $150-$200. The thermocouple is a safety device that senses when the pilot light is burning and signals the gas valve to close if the pilot light goes out. If your thermocouple is bad or corroded, the average cost to clean and repair it could be between $350 and $400. If your water heater has started to leak, it is usually more cost-effective to invest in a new water heater than to repair it, unless you’re covered by a warranty.
"Beginning to end of experience was fantastic! Initial service agent who took my call was friendly and personable. Got me set up for an appointment same day — on a Saturday — no extra charge. And boom, two hours later, Nelson showed up. Nelson listened intentfully, got the picture/scope, got us our quote and we were off to the races. Courteous, fast, clean, insightful, and professional. Thanks, Nelson! "
Our certified premier plumbers provide 5-star service at a competitive price. Our huge selection of high quality plumbing replacement parts on our “Warehouse on Wheels” means most repairs can be made the same day. Our certified premier plumbers are continually trained and qualified to work on all brands. Bonney is the place to call for your residential and commercial plumbing needs.
JJ's Plumbing Repair has no control over, and assumes no responsibility for, the content, privacy policies, or practices of any third party web sites or services. You further acknowledge and agree that JJ's Plumbing Repair shall not be responsible or liable, directly or indirectly, for any damage or loss caused or alleged to be caused by or in connection with use of or reliance on any such content, goods or services available on or through any such web sites or services.
Call us today to learn more about the services that we offer. Look at our company history to know more about the experience we’ve had throughout the years. Go to our services to learn more about the plumbing jobs that we can provide. It has never been easier to hire a plumber in Kuala Lumpur these day. With KL1 Plumber, you can hire a plumber at the comfort of your own home. Call us today!
Home repairs and maintenance shouldn’t get pushed to the bottom of the to-do list. Unfortunately, most people don’t think they need plumbing repair services until there’s an emergency. While some plumbing issues may seem minor, they could actually be serious emergencies in the making. Routine repairs from Mr. Rooter® Plumbing are affordable, and they’ll save you from paying for emergency plumbing rescue in the future.
Being without hot water is no fun. But when you call Houston’s hometown plumbers, John Moore Services, you won’t have to go without hot water for long. Since 1965, Houstonians have counted on John Moore to have their water heaters replaced quickly and correctly. John Moore installs both Traditional and Tankless Water Heaters, so feel free to ask our licensed plumbers any questions you may have if you are interested in making a switch to tankless. Only select water heaters and water heater parts and connections pass our strict quality standards, so you can rest assured that your new water heater will be an efficient, cost-effective solution that will continue to meet your needs safely for many years to come.
Cast iron and ductile iron pipe was long a lower-cost alternative to copper, before the advent of durable plastic materials but special non-conductive fittings must be used where transitions are to be made to other metallic pipes, except for terminal fittings, in order to avoid corrosion owing to electrochemical reactions between dissimilar metals (see galvanic cell).
Nexstar Legacy Foundation: This scholarship is available to qualified people living in the United States, Canada, New Zealand, Australia, and the Cayman Islands. Through the Nexstar Legacy Foundation, there are three different scholarships available for those entering trades such as plumbing. There is the Technician Service Provider Scholarship, an apprenticeship scholarship, and a Troops to Trade scholarship.
I think it is rather rude and a bit dishonest for people to not divulge their total fees upfront, an of course we should know to ask. But the normal person wouldn't know the questions to ask until they are burnt once like this, and then there still could be costs for walking up stairs or charge another service call if they need to go somewhere to use the bathroom and come back. THAT ISN'T A QUESTION I WOULD THINK TO ASK.