"After reaching out to Dallas area Leak Detection company all had me backed out for days for a response. I went to Thumbtack and found DC who was able to get right on the issue of a major leak I had flooding my home near the garage water heater closet. He was determined to find the leak which was diagnosed to be behind the wall and we were able to isolate and only tear out the area of damage and leak and he fixed the busted on the one and only Pex tubing on this house which had hairline crack during this last winter freeze. He fixed the leak and was very professional, responsive and most of all Punctual he drove far because I live up far North Dallas area in Grayson County. Also the value in the repair for where I am located was easier on my budget. I would definitely rehire and go to DC for my future plumbing needs. A real Winner in my book of tradesman."

Needed to replace a water pressure regulator.  Looking at the retail costs of the regulator, they seem to run from abouit $60 to over $300 for one that includes more that the basic control of water pressure in the house.  Had not used a pro plumber for over 20 years so I was not up on the costs associated with needing their help.  I was contacted by at least 3 plumbers but only one, Right Now Plumbers, gave me an instant quote of $394  for the service without me even asking. Although I thought this price seemed a little high for a job that takes less than an hour to complete, I accepted their service.  Must say that the job was done very professionally and would use them again if needed.  However, 

Nationally, the average water heater repair cost ranges between $120 and $200, although prices can range up to $400 or more. Water heater repair costs will depend on the type of water heater you have (tankless, electric, natural gas, etc.), the source of the problem, the cost for new parts, and labor rates in your area. Common water heater issues include problems with the thermocouple, thermostat, heating element and leaks. Most standard electric water heaters have two thermostats and two elements. One example for the cost to replace a bad thermostat is $185 for parts and labor. Replacing both the thermostat and the heating element could cost approximately $150-$200. The thermocouple is a safety device that senses when the pilot light is burning and signals the gas valve to close if the pilot light goes out. If your thermocouple is bad or corroded, the average cost to clean and repair it could be between $350 and $400. If your water heater has started to leak, it is usually more cost-effective to invest in a new water heater than to repair it, unless you’re covered by a warranty.
Commercial buildings rely on their plumbing systems just as much as residential ones. That’s why we offer a full range of commercial plumbing services. Need a new grease trap installed? Old water heater acting up? Don’t worry about it. Our professional technicians will make sure that everything is taken care of the first time, and as quickly as possible. Read More
“Don’t assume that every Mr. Fix-it advertising his services in the local Pennysaver or on Craigslist is a licensed plumber,” says one New York plumber. There is no national standard for issuing licenses. Some plumbers are licensed by the state, others by the counties they work in. Check with your local city hall or chamber of commerce. They should be able to direct you to the appropriate source for a list of licensed plumbers in your area.
Hello I had a plumber do an estimate for me to replace our copper pipes with plastic as we have no existing walls up in our basement yet...pretty basic job... so we figured we could upgrade as we do live in Northern Ontario and it does tend to get quite cold here in the winters.  We dont have any existing problems with our plumbing right now just figured it would be good time to do the job and perhaps change the pipes to 3 quarter inch for faster flow.  Well I never thought in all my life I would get an estimate back that would state $350.00 an hour in labor...yes that is correct $350.00 an hour...estimated 10 hours for the job to be completed.  So he quoted me $3500.00 for labor alone.. not supplies?  Well needless to say I will be happy with my half inch copper pipes and will happily wait for my bathtub to fill up at a slower pace.  Just wanted to know what your thoughts are on this $350.00 an hour quote?  Thank you and enjoy your day.
We understand how frustrating it can be to come home to an unexpected plumbing problem. That is why our team works hard to provide solutions you can trust. Our job is to make your life easier, not add to your plumbing problem. You can expect nothing short of exceptional service from start to finish.As a full-service plumbing company we are able to offer our customers the best solutions using the latest techniques and technology. You can be confident that the job will be completed through safe and proven methods. Because our goal is the same as yours: to make sure you enjoy the safety, comfort, and peace of mind you deserve.
Leaky, dripping, rusting faucets can drive you crazy. Is it time to repair, replace or upgrade your faucets? John Moore, the area's trusted master Houston plumbing team since 1965, can examine your fixtures and help you determine whether it can be repaired or if a new faucet is needed. We have a wide variety of replacement parts on hand to resolve most common faucet repairs quickly. If a new fixture is in your future, John Moore carries the latest styles from the industry’s top brands such as Moen, Kholer, and Delta. Have you decided to freshen up your home’s décor with a new look? Are you interested in adding a sprayer to make doing dishes a little quicker and easier? Or perhaps you want a motion sensitive / touch-free kitchen faucet make washing up more sanitary. Whatever your vision or needs may be, purchasing your faucet and installation from John Moore means that you will receive expert installation of a quality fixture that will last for years to come.

Plumbing Repair Co Denver

×